Exam Dumps VCE

QUESTION 71
What are key characteristics of SupportAssist Enterprise on Dell EMC PowerEdge 14G servers?

QUESTION 72
A technician needs an iDRAC Enterprise feature that meets the following requirements:
– Provides capacity up to 16 GB
– User can create up to 16 partitions that can emulate a floppy drive, hard disk, or CD/DVD depending on selected emulation mode Which feature should the technician use?

QUESTION 73
A system administrator plans to use a remote desktop that has the DRAC tools installed to run RACADM commands.
Which two CLI options must be in the RACADM command?(Select 2)

QUESTION 74
A system administrator, while working with tech support, is asked to check the blinking LEDs on the Dell PowerEdge 16G server.
Where should the administrator look?

QUESTION 75
During a physical Inspection, the System Status LED Is blinking blue. What does this indicate?

QUESTION 76
A PowerEdge server running a virtualization workload shows CPU throttling under load, despite sufficient PSU capacity and no hardware faults. Which configuration is the cause of this issue?

QUESTION 77
From PERC8 to PERC9, the maximum number of individual drives upon which a virtual disk can be created changed.
How did this value change?

QUESTION 78
What is the minimum number of components, beside the system board, required to POST?

QUESTION 79
Which two memory settings optimize a PowerEdge 16G server to support VMware ESXi?

QUESTION 80
What IP address does an administrator connect to the iDRAC Direct USB port?

QUESTION 81
What is a custom form factor mezzanine card that contains a complete NIC subsystem?

QUESTION 82
A new server has 128 GB of RAM and three 1 TB drives. After creating a RAID 5 array with the three internal drives on the system, a technician boots to the Lifecycle Controller to install Windows Server 2016. When the technician tries to select an install location, Windows displays an error message that states that it cannot be installed to that location.
What should the technician do to resolve this issue?

QUESTION 83
What could cause a PowerEdge server power supply LED to blink amber for two seconds and off for one second?

QUESTION 84
A technician needs to configure a server to PXE boot a server setup image with the BIOS in UEFI mode.
Which two steps should the technician perform to enable this function?(Choose two.)

QUESTION 85
A technician configures iDRAC on a new server for access on the management network. When accessing via telnet, the connection is refused. Network connectivity is a verified network. NO ports are blocked by any network devices.
Why is the telnet connection being refused?

QUESTION 86
Which AMD powered server supports dual CPU. 16G, and iDRAC Express?

QUESTION 87
An engineer wants to fully leverage Microsoft Windows Server 2016 for TPM-based guarded host deployment of a 14G server.
Which BIOS settings need to be used for installing the Windows server?
A)

B)

C)

D)

QUESTION 88
What category of error is indicated by HWC8011?

QUESTION 89
A technician is using the iDRAC web GUI to upload a firmware that requires a reboot. They select the update and choose ‘Apply Update and Reboot Now’.
How could the technician determine the status of the firmware update?