Latest Fortinet NSE7_SDW-7.2 PDF and Dumps (2025) Free Exam Questions Answers [Q36-Q56]

Rate this post

Latest Fortinet NSE7_SDW-7.2 PDF and Dumps (2025) Free Exam Questions Answers

Pass Your NSE 7 Network Security Architect NSE7_SDW-7.2 Exam on Sep 04, 2025 with 101 Questions

NEW QUESTION 36
Exhibit.

The exhibit shows VPN event logs on FortiGate. In the output shown in the exhibit, which statement is true?

There are no IPsec tunnel statistics log messages for ADVPN cuts.

There is one shortcut tunnel built from master tunnel T_MPLS_0.

The VPN tunnel T_MPLS_0 is a shortcut tunnel.

The master tunnel T_INET_0 cannot accept the ADVPN shortcut.

NEW QUESTION 37
What are two advantages of using an IPsec recommended template to configure an IPsec tunnel in an hub-and-spoke topology? (Choose two.)

It ensures consistent settings between phase1 and phase2.

It guides the administrator to use Fortinet recommended settings.

It automatically install IPsec tunnels to every spoke when they are added to the FortiManager ADOM.

The VPN monitor tool provides additional statistics for tunnels defined with an IPsec recommended template.

NEW QUESTION 38
Exhibit.

The exhibit shows the output of the command diagnose sys sdwan health-check status collected on a FortiGate
device. Which two statements are correct about the health check status on this FortiGate device? (Choose
two.)

The health-check VPN_PING orders the members according to the lowest jitter.

The interface T_INET_1 missed one SLA target.

There is no SLA criteria configured for the health-check Level3_DNS.

The interface T_INET_0 missed three SLA targets.

NEW QUESTION 39

Exhibit B –

Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?

port1 is assigned a manual IP address.

port1 is referenced in a firewall policy.

port2 is referenced in a static route.

port1 and port2 are not administratively down.

NEW QUESTION 40
Refer to the exhibits.

Exhibit A shows the packet duplication rule configuration, the SD-WAN zone status output, and the sniffer output on FortiGate acting as the sender. Exhibit B shows the sniffer output on a FortiGate acting as the receiver.
The administrator configured packet duplication on both FortiGate devices. The sniffer output on the sender FortiGate shows that FortiGate forwards an ICMP echo request packet over three overlays, but it only receives one reply packet through T_INET_1_0.
Based on the output shown in the exhibits, which two reasons can cause the observed behavior? (Choose two.)

On the receiver FortiGate, packet-de-duplication is enabled.

The ICMP echo request packets sent over T_INET_0_0 and T_MPLS_0 were dropped along the way.

The ICMP echo request packets received over T_INET_0_0 and T_MPLS_0 were offloaded to NPU.

On the sender FortiGate, duplication-max-num is set to 3.

NEW QUESTION 41
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

The FortiGate cloud key has not been added to the FortiGate cloud portal.

FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager

The zero-touch provisioning process has completed internally, behind FortiGate.

FortiGate has obtained a configuration from the platform template in FortiGate cloud.

A factory reset performed on FortiGate.

NEW QUESTION 42
Which diagnostic command can you use to show the configured SD-WAN zones and their assigned members?

diagnose sys sdwan zone

diagnose sys sdwan service

diagnose sys sdwan member

diagnose sys sdwan interface

NEW QUESTION 43
Which are three key routing principles in SD-WAN? (Choose three.)

FortiGate performs route lookups for new sessions only.

Regular policy routes have precedence over SD-WAN rules.

SD-WAN rules have precedence over ISDB routes.

By default, SD-WAN members are skipped if they do not have a valid route to the destination.

By default, SD-WAN rules are skipped if the best route to the destination is not an SD-WAN member.

NEW QUESTION 44
Refer to the exhibit.

The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured packet loss will make T_INET_1_0 the new preferred member?

When all three members have the same packet loss.

When T_INET_0_0 has 4% packet loss.

When T_INET_0_0 has 12% packet loss.

When T_INET_1_0 has 4% packet loss.

NEW QUESTION 45
Exhibit.

The exhibit shows the output of the command diagnose sys sdwan health-check status collected on a FortiGate device. Which two statements are correct about the health check status on this FortiGate device? (Choose two.)

The health-check VPN_PING orders the members according to the lowest jitter.

The interface T_INET_1 missed one SLA target.

There is no SLA criteria configured for the health-check Level3_DNS.

The interface T_INET_0 missed three SLA targets.

NEW QUESTION 46
Refer to the exhibit.

Based on the exhibit, which two statements are correct about the health of the selected members? (Choose two.)

After FortiGate switches to active mode, FortiGate never fails back to passive monitoring.

During passive monitoring, FortiGate can’t detect dead members.

FortiGate can offload the traffic that is subject to passive monitoring to hardware.

FortiGate passively monitors the member if TCP traffic is passing through the member.

NEW QUESTION 47
Refer to the exhibits.
Exhibit A

Exhibit B –

Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status.
The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule.
Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?

The traffic will be load balanced across all three overlays.

The traffic will be routed over T_INET_0_0.

The traffic will be routed over T_MPLS_0.

The traffic will be routed over T_INET_1_0.

NEW QUESTION 48

Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

Create a new firewall policy, and the select the SD-WAN zone as Incoming Interface.

In the traffic shaping policy, select Assign Shaping Class ID as Action.

In the firewall policy, select Proxy-based as Inspection Mode.

In the traffic shaping policy, enable Reverse shaper, and then select the traffic shaper to use.

NEW QUESTION 49
Refer to the exhibit.

The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths.
However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths.
Based on the exhibit, which three settings must the administrator configure inside each BGP neighbor group so spokes can learn other spokes prefixes and their additional paths? (Choose three.)

Setadditional-pathtosend

Enableroute-reflector-client

Setadvertisement-intervalto the number of additional paths to advertise

Setadv-additional-pathto the number of additional paths to advertise

Enablesoft-reconfiguration

NEW QUESTION 50
Refer to the exhibit.

The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device?
(Choose two.)

Each BGP route is three hops away from the destination.

ibgp-multipath is disabled.

additional-path is enabled.

You can run the get router info routing-table database command to display the additional paths.

NEW QUESTION 51
Refer to the exhibit.

Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?

All traffic from a source IP to a destination IP is sent to the same interface.

All traffic from a source IP is sent to the same interface.

All traffic from a source IP is sent to the most used interface.

All traffic from a source IP to a destination IP is sent to the least used interface.

NEW QUESTION 52
What are two common use cases for remote internet access (RIA)? (Choose two.)

Provide direct internet access on spokes

Provide internet access through the hub

Centralize security inspection on the hub

Provide thorough inspection on spokes

NEW QUESTION 53
Which diagnostic command can you use to show the member utilization statistics measured by performance
SLAs for the last 10 minutes?

diagnose sys sdwan sla-log

diagnose ays sdwan health-check

diagnose sys sdwan intf-sla-log

diagnose sys sdwan log

NEW QUESTION 54
Refer to the exhibit.

Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change?
(Choose two.)

FortiGate flushes all sessions.

FortiGate terminates the old sessions.

FortiGate does not change existing sessions.

FortiGate evaluates new sessions.

NEW QUESTION 55
What is the route-tag setting in an SD-WAN rule used for?

To indicate the routes that can be used for routing SD-WAN traffic.

To indicate the members that can be used to route SD-WAN traffic.

To indicate the destination of a rule based on learned BGP prefixes.

To indicate the routes for health check probes.

NEW QUESTION 56
What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)

It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.

It improves SD-WAN performance on the managed FortiGate devices.

It sends probe signals as health checks to the beacon servers on behalf of FortiGate.

It acts as a policy compliance entity to review all managed FortiGate devices.

It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.

Fortinet NSE7_SDW-7.2 Exam Syllabus Topics:

Topic	Details
Topic 1	Centralized Management: This area focuses on deploying and managing SD-WAN through FortiManager, including using IPsec templates and SD-WAN Overlay Templates. Mastery here demonstrates the abilities of Fortinet network and security professionals to streamline SD-WAN configuration, enhance security, and maintain consistent policies across multiple sites.
Topic 2	Rules and Routing: Understanding SD-WAN Rules and Routing is crucial for directing traffic effectively. This topic of the NSE7_SDW-7.2 exam evaluates the capabilities of Fortinet network and security professionals to configure SD-WAN rules and routing.
Topic 3	SD-WAN Configuration: This topic assesses skills of Fortinet network and security professionals in setting up basic SD-WAN environments, including configuring Direct Internet Access (DIA), SD-WAN Members, and Performance Service Level Agreements (SLAs). Proficiency here ensures the ability to design efficient and resilient SD-WAN configurations.
Topic 4	SD-WAN Overlay Design and Best Practices: It focuses on the deployment of hub-and-spoke IPsec topologies and configuring ADVPN. Proficiency in this topic ensures that Fortinet network and security professionals can implement effective and reliable SD-WAN overlays tailored to organizational needs.
Topic 5	SD-WAN Troubleshooting: Troubleshooting SD-WAN issues, including rules, routing, and ADVPN, is vital for maintaining network reliability. This section of the Fortinet NSE 7 – SD-WAN 7.2 exam tests the ability to diagnose and resolve SD-WAN problems using diagnostic commands and monitoring tools, ensuring robust and uninterrupted network operations.

NSE7_SDW-7.2 Dumps for NSE 7 Network Security Architect Certified Exam Questions and Answer: https://www.examdumpsvce.com/NSE7_SDW-7.2-valid-exam-dumps.html

Exam Dumps VCE

Latest Fortinet NSE7_SDW-7.2 PDF and Dumps (2025) Free Exam Questions Answers [Q36-Q56]

Fortinet NSE7_SDW-7.2 Exam Syllabus Topics:

Leave a Reply Cancel reply