Exam Dumps VCE

Q39. ISO SA 2.5 is defined as:

Q40. The least effective method of surface cleaning is most likely

Q41. You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:

Q42. You are asked to be the only coating inspector on a small bridge recoating job where existing coating contains lead. The owners’ representative has supplied you with the local code governing the removal and disposal of lead based coatings, however upon reading the document you having great deal of difficulty understanding the technical language.
As a NACE CIP Level 1 Inspector your preferred course of action is to:

Q43. Prior to using Inspection Tools the inspector must:

Q44. You are the NACE Inspector on a job where ISO ST 3 has been specified. The Contractor normally works to SSPC standards and been referencing SSPC SP 3.
Could this have any impact on the final surface preparation appearance?

Q45. Whenever dissimilar metals must join, the most common practice is to

Q46. Silicone coatings are typically:

Q47. Checking is

Q48. You are an inspector on a project where SSPC SP 3 is specified.
What sort of tools should you expect the Contractor to use to achieve the standard?

Q49. To achieve consistently accurate results with ALL alt test equipment

Q50. When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

Q51. ASTM Standards are applicable:

Q52. ISO ST 3 is described as:

Q53. Which one of the following documents is the best source for coating technical data:

Q54. Which one of these elements is not necessary for corrosion to occur:

Q55. When working as a NACE Inspector in a situation where there is a difference of opinion, the Inspector needs to:

Q56. A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?

Q57. When using a sling physchrometer a very large difference between the wet and dry bulb readings indicates:

Q58. The primary difference between Non-Convertible vs. Convertible coatings is:

Q59. You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

Q60. The main responsibilities of the inspector are to

Q61. The initial steel condition is important to the NACE Inspector because: