Exam Dumps VCE

QUESTION 39
In Cisco Unified Communications Manager, which tool do you use to check SIP traces?

QUESTION 40
Which configuration element of a hunt group allows for changing Calling Party Transformations settings?

QUESTION 41
A user in location X dials an extension at location Y.
The call travels through a QoS-enabled WAN network, but the user experiences choppy or clipped audio. What is the cause of this issue?

QUESTION 42
Refer to the exhibit.

An administrator is troubleshooting why users are not hearing audio when dialing long distance numbers across their Cisco Unified Border Element. The customer’s carrier has a requirement that dialing long distance requires an access code to be entered. Looking at the exhibit, what two actions can be taken to correct signaling? (Choose two.)

QUESTION 43
Refer to the exhibit.

A call mode through the Cisco Unified Border Element to pilot 2000 is foiling. What is causing the call to foil?

QUESTION 44
A network engineer designs a new dial plan and wants to block a certain range of numbers (8135100 through
8135105). What is the most specific route pattern that can be configured to block only the numbers in this range?

QUESTION 45
A company has an SRST gateway running an IOS XE image. The company plans to enable the IPv6 addressing companywide. To enable the IPv6 in a unified SRST gateway to support SIP phones, what are two supported supplementary features for an IPv6 fallback scenario? (Choose two.)

QUESTION 46
Refer to the exhibit.

An administrator is troubleshooting a situation where a call placed from a phone registered to Cisco Unified Communications Manager does not complete. The administrator wants to use the Dialed Number Analyzer on Cisco Unified CM to check which translation pattern the call is matching. However, when logging in to Cisco Unified Serviceability there is no option for Dialed Number Analyzer under the tool menu. Which two steps must be performed to resolve this issue? (Choose two.)

QUESTION 47
You see the voice register pool 1 command in your Cisco Unified Communications Manager Express configuration. Which configuration is occurring in this section?

QUESTION 48
An administrator is configuring a cluster for ILS and wants to limit the amount of entities that Cisco Unified Communications Manager can write to the database for data that is learned through ILS. Which service parameter is used to adjust this limit?

QUESTION 49
Which configuration must an administrator perform to display Translation Pattern operations in Cisco Unified Communications Manager SDL traces?

QUESTION 50
What are two configureation features of the Client matter code setting in the route pattern configuration? (Choose two.)

QUESTION 51
When the services key is pressed Cisco Extension Mobility does not show up. What is the cause of the issue?

QUESTION 52
Refer to the exhibit.

An administrator is troubleshooting why users are not hearing audio when dialing long distance numbers across their Cisco Unified Border Element. The customer’s carrier has a requirement that dialing long distance requires an access code to be entered. Looking at the exhibit, what two actions can be taken to correct signaling? (Choose two.)

QUESTION 53
Refer to the exhibit.

Within the North American Numbering Plan, gateways located in Ottawa, Canada and marked as “YOW” are assigned to the Calling Party Transformation CSS NANP_CgPTP, which contains partition NANP_calling_xforms. What is the calling-party number and the numbering type if the calling user +1613-555-1234 dials the number?

QUESTION 54
If all patterns below are configured in Cisco Unified Communications Manager which would be used when dialing the pattern “123”?

QUESTION 55
Refer to the exhibit. A standard local route group is configured for long-distance calls. Calls from building A succeed, but calls from building B fail. On the system. Each building has is own device pool. The DNA tool is used to test the configuration. How is this issue resolved?

QUESTION 56
Which services are needed to successfully implement Cisco Extension Mobility in a standalone Cisco Unified Communications Manager server?