Exam Dumps VCE

NO.37 What are two functions of MPLS Layer 3 VPNs? (Choose two.)

NO.38 Refer to the exhibit.

Which two actions should be taken to access the server? (Choose two.)

NO.39 A network administrator performed a Compact Flash Memory upgrade on a Cisco Catalyst 6509 Switch. Everything is functioning normally except SNMP, which was configured to monitor the bandwidth of key interfaces but the interface indexes are changed. Which global configuration resolves the issue?

NO.40 Refer to the exhibit. R4 is experiencing packet drop when trying to reach 172.16.2.7 behind R2.
Which action resolves the issue?

NO.41 In order to connect between disparate OSPF and EIGRP portions of a network, mutual route
redistribution has been configured. What are two disadvantages of doing this? (Choose two.)

NO.42 What is the minimum time gap required by the local system before putting a BFD control packet on the wire?

NO.43 Refer to the exhibit.

The administrator configured route advertisement to a remote low resources router to use only the default route to reach any network but failed. Which action resolves this issue?

NO.44 Refer to the exhibit.

An engineer is monitoring reachability of the configured default routes to ISP1 and ISP2. The default route from ISP1 is preferred if available. How is this issue resolved?

NO.45 Refer to the exhibit. The Los Angeles and New York routers are receiving routes from Chicago
but not from each other.
Which configuration fixes the issue?
Refer to the exhibit. The Los Angeles and New York routers are receiving routes from Chicago
but not from each other.
Which configuration fixes the issue?

NO.46 An engineer configured VRF-Lite on a router for VRF blue and VRF red. OSPF must be enabled on each VRF to peer to a directly connected router in each VRF. Which configuration forms OSPF neighbors over the network 10.10.10.0/28 for VRF blue and 192.168.0.0/30 for VRF red?

NO.47 An engineer configured Reverse Path Forwarding on an interface and noticed that the routes are dropped when a route lookup fails on that interface for a prefix that is available in the routing table Which interface configuration resolves the issue?

NO.48 Refer to the exhibit.

A user cannot SSH to the router. What action must be taken to resolve this issue?

NO.49 A network administrator cannot connect to a device via SSH. The line vty configuration is as follows:

Which action resolves this issue?

NO.50 Refer to the exhibit. Reachability between servers in a network deployed with DHCPv6 is unstable. Which command must be removed from the configuration to make DHCPv6 function?

NO.51 Refer to the exhibit.

Which action resolves the failed authentication attempt to the router?

NO.52 Refer to the exhibit.

An engineer configured IP SLA on R1 to avoid the ISP link flapping problem. but it is not working as designed IP SLA should wait 30 seconds before switching traffic to a secondary connection and then revert to the primary link after waning 20 seconds, when the primary link is available and stabilized. Which configuration resolves the issue?

NO.53 Refer to the exhibit.

With the partial configuration of a router-on-a-stick. Clients in VLAN 10 on Gi2 cannot obtain IP configuration from the central DHP server is reachable by a successful ping from the route. Which action resolves the issue?

NO.54 Refer to the exhibit. After applying IPsec, the engineer observed that the DMVPN tunnel went
down, and both spoke-to-spoke and hub were not establishing.
Which two actions resolve the issue? (Choose two.)

NO.55 Refer to Exhibit.

Which statement about redistribution from BGP into OSPF process 10 is true?

NO.56 Which control plane process allows the MPLS forwarding state to recover when a secondary RP
takes over from a failed primary RP?

NO.57 Refer to the exhibit.


All the serial between R1, R2, and R3 have the Same bandwidth. User on the 192.168.1.0/24 network report slow response times while they access resource on network 192.168.3.0/24. When a traceroute is run on the path. It shows that the packet is getting forwarded via R2 to R3 although the link between R1 and R3 is still up. What must the network administrator to fix the slowness?

NO.58 Refer to the exhibit.

The R2 loopback interface is advertised with RIP and EIGRP using default values. Which configuration changes make R1 reach the R2 loopback using RIP?

NO.59


Refer to the exhibit R2 has been receiving routes from R4 that originated outside AS300 A network engineer configured an AS-Path ACL to avoid adding these routes to the R2 BGP table but the routes are still present in the R2 routing table Which action resolves the issue?

NO.60 Refer to the exhibit.

An engineer must establish a point-to-point GRE VPN between R1 and the remote site. Which configuration accomplishes the task for the remote site?

NO.61 Refer to the exhibit.

An administrator is configuring a GRE tunnel to establish an EIGRP neighbor to a remote router. The other tunnel endpoint is already configured. After applying the configuration as shown, the tunnel started flapping.
Which action resolves the issue?