Exam Dumps VCE

NEW QUESTION 66
Refer to the exhibit. Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is enabled?

NEW QUESTION 67
Refer to the exhibit.


Refer to the exhibit. The service provider operations team was alerted that hub site traffic from BGP AS 65101 to AS 65201 uses a non-primary path via the R5-R6 link. IBGP peering between R1 and R2 is up. and no fiber failure has been reported on the R2-R3 link The team determined that the traffic flow between 10.10.10.1 and 192.168.30.1 is not considering the R1-R2-R3-R4 path. Which action resolves this issue?

NEW QUESTION 68
Refer to the exhibit

An engineer is configuring service traffic from router R1 to R6 as shown. Which additional configuration must the engineer implement so that the LDP and SR domains will participate and interwork with each other?

NEW QUESTION 69
Refer to the exhibit.

IS-IS is the routing protocol on the network. After the team noticed excessive CPU usage on all routers, particularly routers R2 and R6, they configured route summarization on all routers. However, a network engineer noticed that summary routes and more specific routes are present in the routing table on R1. Which action must the team take so that R1 receives only the summary routes?

NEW QUESTION 70
Refer to the exhibit.

Routers R1 and R2 reside in AS 65530, which is multihomed to the Internet. A network engineer expects devices in the AS to use R2 to access the Internet, but they are using R1 as the exit point from the AS. Which action corrects the problem?

NEW QUESTION 71
Refer to the exhibit.

An engineer working for a private telecommunication company with an employee id 3977 74 814 implemented the configuration on Router 1. what is the effect of it?

NEW QUESTION 72
Refer to the exhibit.

An engineer is comparing these RPL and route map configurations. Which two conclusions will the engineer reach? (Choose two.)

NEW QUESTION 73
Refer to the exhibit.

Routers R1, R2. R3, and R4 have been configured to run OSPF. and router R5 is running EIGRP Traffic from R1 to R5 is expected to pass via R4. but OSPF routing has calculated the best path via R3. Which action corrects the problem?

NEW QUESTION 74
Refer to the exhibit.

After troubleshooting an OSPF adjacency issue, routers 1, 2, and 3 have formed OSPF neighbor relationships. Which statement about the configuration is true?

NEW QUESTION 75
Refer to the exhibit. Users connected to an application on 1.1.1.1 via routers CE1 and CE2 are complaining of frequent disconnections. While troubleshooting the issue, a network engineer with an employee ID: 1234:56:789 determined that the application itself is working normally, but the link connected to the 1.1.1.1 application is flapping. The users on CE1 and CE2 are accessing applications on 2.2.2.2 without difficulty. Which action resolves the issue?

NEW QUESTION 76
Drag and drop the features about multicast from the left onto the multicast protocols on the right. Not all options ate used.

NEW QUESTION 77
The operator must leverage automated steering and coloring with the design. Which two elements from an SR Policy tuple are used for automated steering inside of the network? (Choose two.)

NEW QUESTION 78
Refer to the exhibit.

Routers R1 and R2 cannot form a neighbor relationship, but the network is otherwise configured correctly and operating normally. Which two statements describe the problem? (Choose two.)

NEW QUESTION 79
A network engineer is troubleshooting OSPF multiare A. Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?

NEW QUESTION 80
A network administrator working for a private service provider with an employee ID: 4872:46:269 wants to configure timers for the BGP process on their Cisco IOS XE router. Which configuration follows guideline timer recommendations and is a valid BGP timer deployment?

NEW QUESTION 81
Refer to the exhibit. Traffic flow from router R1 to router R6 is delay-sensitive. It must consider potential link-failure and node-failure conditions.
Which configuration must an engineer apply to router R1 to route traffic to router R6 if router R2 fails?

NEW QUESTION 82
An engineer is troubleshooting end-to-end customer traffic across an MPLS VPN service provider network. Which tasks should the engineer use to solve the routing issues? Drag and drop the table types from the left onto the most useful troubleshooting tasks/router types on the right. (Not all options are used.)

NEW QUESTION 83

Refer to the exhibit. Routers CE1 and CE2 are in AS 65530. which is multihomed for Internet access. An engineer expects inbound traffic to AS 65530 to arrive from PE1. but it is coming from PE2 instead PE1 and PE2 routers are connected with CE routers through the same bandwidth Which action must be taken to correct the problem?