Tested & Approved NSE6_FSW-7.2 Study Materials Download Free Updated 56 Questions [Q29-Q47]

Rate this post

Tested & Approved NSE6_FSW-7.2 Study Materials Download Free Updated 56 Questions

Regular Free Updates NSE6_FSW-7.2 Dumps Real Exam Questions Test Engine

Fortinet NSE6_FSW-7.2 certification exam is ideal for network administrators who want to demonstrate their expertise in managing FortiSwitches. Fortinet NSE 6 – FortiSwitch 7.2 certification also validates the skills of security professionals who want to enhance their knowledge of network security. NSE6_FSW-7.2 exam is designed to test the candidate’s ability to configure and manage FortiSwitches and ensure that the network is secure and reliable.

QUESTION 29
Which drop policy mode, if assigned to a congested port, will drop incoming packets until there is no congestion on the egress port?

Tail-drop mode

Weighted round robin mode.

Random early detection mode

Strict mode

QUESTION 30
Which two statements about managing a FortiSwitch stack on FortiGate are true? (Choose two.)

A FortiLink interface must be enabled on FortiGate.

The switch controller feature must be enabled on FortiGate.

Only a hardware-based FortiGate can manage a FortiSwitch stack.

FortiSwitch must be operating in standalone mode before authorization.

QUESTION 31
To enhance service in emergency situations, to which LLDP-MED Type-Length-Values does Forti-Switch advertise to IP phones?

Network policy

Inventory management

Location

Power management

QUESTION 32
Refer to the diagnostic output:

Two entries in the exhibit show that the same MAC address has been used in two different VLANs. Which MAC address is shown in the above output?

It is a MAC address of FortiLink interface on FortiGate.

It is a MAC address of a switch that accepts multiple VLANs.

It is a MAC address of an upstream FortiSwitch.

It is a MAC address of FortiGate in HA configuration.

QUESTION 33
What type of multimode transceiver can be used to split a 40G port?

QSFP+ transceiver

SFP transceiver

QSFP transceiver

SFP+ transceiver

QUESTION 34
FortiGate is unable to establish a tunnel with the FortiSwitch device it is supposed to manage Based on the debug output shown in the exhibit, what is the reason for the failure?

The handshake process timed out before FortiSwitch responded.

DTLS client hello had the incorrect pre-shared key.

The CAPWAP tunnel failed to come up due to a mismatch in time.

FortiSwitch has disabled FortiLink and is only managed as a standalone.

QUESTION 35
Which statement about using MAC, IP, and protocol-based VLANs on FortiSwitch is true?

lt is a scalable and secure solution in comparison to other Layer 2 security measures.

FortiSwitch uses only the Ethernet type to assign traffic to VLANs.

It provides benefits that can be obtained when using 802.1X authentication.

Endpoints are required to use the same FortiSwitch port to remain members of the VLAN.

QUESTION 36
Refer to the exhibit.

The profile shown in the exhibit is assigned to a group of managed FortiSwitch ports, and these ports are connected to endpoints which are powered by PoE.
Which configuration action can you perform on the LLDP profile to cause these endpoints to exchange PoE information and negotiate power with the managed FortiSwitch?

Create new a LLDP-MED application type to define the PoE parameters.

Assign a new LLDP profile to handle different LLDP-MED TLVs.

Define an LLDP-MED location ID to use standard protocols for power.

Add power management as part of LLDP-MED TLVs to advertise.

QUESTION 37
How is traffic routed on FortiSwitch?

Hardware-based routing on FortiSwitch is handled by the CPU.

FortiSwitch looks up the hardware routing table and then the forwarding information base (FIB).

ASIC hardware routing can only handle dynamic routing, if supported.

Layer 3 routing can be configured on FortiSwitch, while managed by FortiGate.

QUESTION 38
Exhibit.

Which configuration change will allow the managed FortiSwitch to accept SNMP requests from any source?

Create a new local access profile for SNMP only.

Enable SNMP on the internal interface of the switch.

Configure an SNMP host to send SNMP traps.

Add SNMP service on the management interface of the switch.

QUESTION 39
Which statement about the configuration of VLANs on a managed FortiSwitch port is true?

Untagged VLANs must be part of the allowed VLANs: ingress and egress.

FortiSwitch VLAN interfaces are created only when FortiSwitch is managed by Forti-Gate.

The native VLAN is implicitly part of the allowed VLAN on the port.

Allowed VLANS expand the collision domain to the port.

QUESTION 40
Refer to the configuration:

Which two conditions does FortiSwitch need to meet to successfully configure the options shown in the exhibit above? (Choose two.)

The FortiSwitch model is equipped with a maximum of 54 interfaces

FortiSwitch would need to be rebooted.

The split port can be assigned to a native VLAN.

The Dort full speed prior to the split was 100G QSFP+.

QUESTION 41
How does FortiSwitch perform actions on ingress and egress traffic using the access control list (ACL)?

Only high-end FortiSwitch models support ACL.

ACL can be used only at the prelookup stage in the traffic processing pipeline.

Classifiers enable matching traffic based only on the VLAN ID.

FortiSwitch checks ACL policies only from top to bottom.

QUESTION 42
Which Ethernet frame can create Layer 2 flooding due to all bytes on the destination MAC address being set to all FF?

The broadcast Ethernet frame

The unicast Ethernet frame

The multicast Ethernet frame

The anycast Ethernet frame

QUESTION 43
How are the ‘by VLAN redirect MAC address quarantine’ mode and the ‘by redirect MAC address quarantine’ mode on FortiGate similar?

Both modes move quarantined devices to the quarantine VLAN.

Both modes require firewall policies to block inter-VLAN traffic.

Both modes add quarantined device MAC addresses to the blocked firewall address group.

Both modes block intra-VLAN traffic by FortiGate automatically.

QUESTION 44
Which statement about the IGMP snooping querier when enabled on a VLAN is true?

Active multicast receiver entries are aging on each IGMP query sent on the VLAN

IGMP reports on the VLAN are forwarded to all switch ports.

The setting can only be enabled using the FortiSwitch CLI.

All other indirectly connected switches will be unable to get IGMP multicast traffic.

QUESTION 45
Which statement about 802.1X security profiles using MAC-based authentication mode is true?

FortiSwitch allows connectivity to all hosts connected to a port, if one host is authenticated.

FortiSwitch can grant each device a different access level based on the credentials provided

FortiSwitch performs faster when using this security mode on the ports.

FortiSwitch must communicate with the RADIUS server to authenticate devices

QUESTION 46
Which two rules used by MSTP are similar to rules used by other STP methods? (Choose two.)

MSTP uses port role election, similar to rapid STP on the instances.

MSTP uses alternate path and primary path, similar to regular STP.

MSTP uses root bridge selection, similar to rapid STP

MSTP uses timers for transitioning the ports, similar to regular STP.

QUESTION 47
Exhibit.

You need to manage three FortiSwitch devices using a FortiGate device. Two of the FortiSwitch devices initiated a reboot after the authorization process. However, the FortiSwitch device with the configuration shown in the exhibit. did not reboot All three devices completed FortiLink manage-ment authorization successfully.
Why did the FortiSwitch device shown in the exhibit not reboot to complete the authorization pro-cess?
The management mode was set to use FortiLink mode.

Switch auto-discovery is enabled.

The management mode was set to use FortiLink mode.

The FortiSwitch device is scheduled to reboot as part the authorization process

The system time is not in-sync and is using a non-default value

Loading …

Fortinet NSE6_FSW-7.2 certification exam is designed for professionals who want to validate their skills and knowledge in FortiSwitch 7.2 technology. NSE6_FSW-7.2 exam is part of the Fortinet Network Security Expert (NSE) program, which is a comprehensive training and certification program that covers all aspects of network security. The NSE6_FSW-7.2 exam is intended for network administrators, security professionals, and IT managers who are responsible for deploying, configuring, and managing FortiSwitch 7.2 solutions.

Pass Fortinet NSE6_FSW-7.2 Exam in First Attempt Easily: https://www.examdumpsvce.com/NSE6_FSW-7.2-valid-exam-dumps.html