Rate this post

[Mar 10, 2024] JN0-682 Exam Dumps PDF Updated Dump from ExamDumpsVCE Guaranteed Success

Pass Your Juniper Exam with JN0-682 Exam Dumps

The JN0-682 exam is a comprehensive test that covers a wide range of topics related to data center technologies. JN0-682 exam tests the candidate’s knowledge of data center architecture, data center interconnect technologies, data center security, data center virtualization, data center automation, and orchestration. JN0-682 exam also tests the candidate’s ability to deploy and configure Juniper Networks data center technologies such as Junos Fusion Data Center, Virtual Chassis Fabric, and QFX Series Switches.

Juniper JN0-682 Exam Syllabus Topics:

Topic Details
Topic 1
  • Describe data center management concepts
  • Describe single-tenant and multi-tenant architectures
Topic 2
  • Demonstrate knowledge of configuring, monitoring, or troubleshooting IP Fabrics
  • Filter-based forwarding
Topic 3
  • EVPN architectures, including Centrally-Routed Bridging (CRB) and Edge-Routed Bridging (ERB)
  • Describe IP Fabric concepts
Topic 4
  • Describe data center security concepts
  • Describe data center deployment concepts
Topic 5
  • Data Center Architecture and Security
  • EVPN-signaled VXLAN for DCI
  • Interconnect network types
Topic 6
  • Demonstrate knowledge of configuring, monitoring, or troubleshooting VXLAN
  • Zero Touch provisioning
Topic 7
  • Data Center Deployment or Management
  • Data Center Interconnect

 

NEW QUESTION 60
Exhibit.


The configuration shown in the exhibit is intended to set up assisted replication but will not commit.
Which action will create a valid configuration in this situation?

 
 
 
 

NEW QUESTION 61
You have deployed a multitenant EVPN-VXLAN fabric. You must have the routes in the BLUE VRF show up in the RED VRF. In this scenario, how would you achieve this goal?


 
 
 
 

NEW QUESTION 62
Referring to the exhibit, DC1 and DC2 have a DCI across a service provider WAN connection.
Host1 in DC1 must have Layer 2 connectivity to host2 in DC2. A VXLAN tunnel must be created between VTEP1 and VTEP2.
In this scenario, which statement is true?

 
 
 
 

NEW QUESTION 63
You are evaluating which method to use for learning MAC addresses in your VXLAN network. Which statement is true in this scenario?

 
 
 
 

NEW QUESTION 64
Site 1 contains 20+ VMs. The link between Site 1 and Leaf1 goes down.
Referring to the exhibit, which statement is correct?

 
 
 
 

NEW QUESTION 65
You are implementing perimeter security for your data center. You need to inspect all traffic Layer 7 and ensure the failure of a port or device will not result in an interruption to traffic flows. In this scenario, which design would satisfy these requirements?

 
 
 
 

NEW QUESTION 66
You are asked to configure VXLAN for you c data center using multicast to exchange VTEP information?
In this scenario, which two configuration parameters must match on the VTEPs in the same VXLAN segment?
(Choose two.)

 
 
 
 

NEW QUESTION 67
You are asked to deploy an Ethernet bridging design in a data center with the following criteria:
–routing must occur on the leaf devices.
–VTEPs must terminate on the leaf devices.
–facilitate inter-VLAN communication, — lower latency with East-West traffic.
Which architecture should you use in this scenario?

 
 
 
 

NEW QUESTION 68
Referring to the exhibit,

you have a data center in which only the spine devices are using EVPN and VXLAN. The leaf nodes are multihomed in active-active mode to the spine nodes through ESI LAG interfaces. In this design, a link failure on the interface connecting the spine nodes would also cause all traffic from the spine to the leaf nodes to drop.
In this scenario, which command configured on which nodes would solve this problem?

 
 
 
 

NEW QUESTION 69
Exhibit.

Referring to the exhibit, you have a data center in which only the spine devices are using EVPN and VXLAN. The leaf nodes are multihomed in active-active mode to the spine nodes through ESI LAG interfaces. In this design, a link failure on the interface connecting the spine nodes would also cause all traffic from the spine to the leaf nodes to drop.
In this scenario, which command configured on which nodes would solve this problem?

 
 
 
 

NEW QUESTION 70
Referring to the exhibit, each node in the IP fabric is peering to its directly attached neighbor using EBGP. Each node is peering using physical interface IP addresses. Leaf 2 and Leaf 3 are advertising the 10.1.1/24 network into EBGP. Spine 2 must be configured so that it can load- share traffic destined to the 10 1.1/24 network over both next-hop A and next-hop B.

Which two actions must be performed to accomplish this task? (Choose two.)

 
 
 
 

NEW QUESTION 71
Which protocol is used between VCF member devices to create a loop-free topology?

 
 
 
 

NEW QUESTION 72
Which EVPN router type prevents BUM traffic from looping back to a multihued host?

 
 
 
 

NEW QUESTION 73
You are considering deploying a MAC-VRF type routing instance with a VLAN-bundle service type. In this scenario, which two statements are correct? (Choose two.)

 
 
 
 

NEW QUESTION 74
Application developers are complaining that east-west server traffic is not being load balanced in your new data center. What are three reasons for this behavior? (Choose three.)

 
 
 
 
 

NEW QUESTION 75
You are asked to enable plug-and-play line card switches in an active VCF without making any future Junos
configuration charges. You are also required to ensure that all new line card are automatically upgrade to the
correct Junos version without any manual intervention.
In this scenario, which two actions will accomplish this task? (Choose two.)

 
 
 
 

NEW QUESTION 76
Which event triggers the generation of a EVPN type-4 route?

 
 
 
 

NEW QUESTION 77
Your colleague has begun working on the base configuration for an active-active multihomed EVPN
connection shown in the exhibit.

Which two actions will ensure a successful implementation? (Choose two.)

 
 
 
 

NEW QUESTION 78
You are deploying a switch using ZTP.
Which two statements are true in this scenario? (Choose two.)

 
 
 
 

Juniper JN0-682 is a professional-level certification exam designed for individuals who want to validate their knowledge and skills in data center technologies. Data Center, Professional (JNCIP-DC) certification is intended for professionals who have experience with Juniper Networks data center solutions and are looking to advance their career in this field. JN0-682 is part of the Juniper Networks Certification Program (JNCP) and is a requirement for the JNCIP-DC certification.

 

New Real JN0-682 Exam Dumps Questions: https://www.examdumpsvce.com/JN0-682-valid-exam-dumps.html

         

Related Links: myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt www.stes.tyc.edu.tw

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter the text from the image below