Exam Dumps VCE

NEW QUESTION 53
Exhibit:

An administrator has a FlexPod solution configured for Microsoft Hyper-V 2012 R2. The UCS blade servers are configured for SAN boot, and all zoning and LUN mapping for a single 50 GB LUN have been configured.
When selecting the install disk during the Windows installation, the symptoms and error shown in the exhibit are displayed.
What should the administrator do to solve the problem?

NEW QUESTION 54
Which management tool is used to configure and monitor centralized policies for multiple Cisco UCS domains?

NEW QUESTION 55
You are installing two NetApp FAS8080 EX controllers.
Which two ports would you use for HA connectivity? (Choose two.)

NEW QUESTION 56
An administrator has a FlexPod solution and is using OnCommand Unified Manager and OnCommand Performance Manager to monitor the FlexPod environment. Full integration has previously been configured between the two OnCommand virtual appliances; however, new performance issues are not being seen in the OnCommand Unified Manager dashboard.
In this scenario, which two settings should the administrator verify? (Choose two.)

NEW QUESTION 57
When using Clustered Data ONTAP 8.1 and later, what is the default for new aggregates?

NEW QUESTION 58
How are jumbo frames enabled on the Nexus 5548?

NEW QUESTION 59
An administrator has a FlexPod solution with VMware vSphere. The administrator is migrating all network traffic from standard switches to vSphere distributed switches.
Virtual machines (VMs) are currently using VM port groups called VLAN_500 and VLAN_501 on standard virtual switch vSwitch3. A new distributed switch called dvSwitch_VM is created and new distributed port groups are configured for each VM traffic VLAN. VMs are configured to use the new port groups.
After the change, VMs on VLAN 501 report a loss of network connectivity; however, VMs on VLAN 500 are not showing any connectivity issues. The symptoms are experienced for VMs on all ESXi hosts.
Which action must the administrator perform to solve the problem?

NEW QUESTION 60
Which three elements are included in a UCS service profile? (Choose three.)

NEW QUESTION 61
Exhibit:

Your customer has a FlexPod VMware solution deployed with NFS datastores. As shown in the exhibit, the links between the Fabric Interconnects and storage controllers are single-mode interface groups with autorevert set to true, hosting a single access LIF. NFS I/O is currently going through fabric A to ST-A. The customer wants to use both fabrics for NFS I/O.
In this scenario, what will accomplish this task?

NEW QUESTION 62
Which endpoint’s firmware can be directly upgraded (without the use of a Service Profile) using UCS Manager?

NEW QUESTION 63
Where are log files located on a NetApp node?

NEW QUESTION 64
Which statement is true about NFS exports in Clustered Data ONTAP?

NEW QUESTION 65
An administrator has a Flexpod solution configured to use VMware vSphere 6.0. All virtual machines will reside on NAS datastores. Certain critical virtual machines have a requirement to use eager-zeroed thick provisioning.
In this scenario, which VMware capability should the administrator enable to satisfy the performance requirement?

NEW QUESTION 66
Which two NetApp storage solutions are supported in FlexPod solutions? (Choose two.)

NEW QUESTION 67
You are asked to create an interface group on a NetApp clustered Data ONTAP system. The system is connected to a Cisco Nexus switch in a vPC configuration with the port-channel mode set to active.
Which NetApp interface group made matches this switch configuration?

NEW QUESTION 68
Which service may be used to manage users and groups in a vSphere environment?